Mend > Lawn Mowers

Mend Murray Q Lawnmower Repair Briggs And Stratton

How can I fix my push lawnmower Murray(Briggs and Stratton)20" 4.75hp Q?

It started putting out black smoke, then it started running uneven(it would run and lapse, run and lapse) then it stopped altogether. I checked the air filter, dirty as hell so cleaned it with K&N cleaner and oiled it with light coat of K&N oil. No dice, same story. Checked the spark plug: Corroded on the tip and the post and electrode were blackened. Post looked good though, not worn. The cable was corroded at the booth connector. Removed the sparkplug and cleaned it. Removed the sparkplug wire assembly which includes the "thing" that rubs against the other thing that rotates when you pull the rope(highly technical lingo). Cleaned the wire's booth connector. Separated it from the wire and cleaned the wire where it connects to the booth connector. Put it back together and added dyelectric grease. Added oil to crankcase. Still nothing. Sorry I cannot be more specific with the names of the parts but any help will be greatly appreciated.
My guess is that i need to replace the sparkplug and the sparkplug wire assembly and that this assembly needs to be gapped to the rotor thingy. Oh... by the way... what is the gap for the sparkplug? I have tried .014,.015 and .016 and no dice. (I dropped the sparkplug and it landed on the electrode, so I had to regap).

Hugo
September 2005

Murray Murray Q Garden Tools, Lawn Mowers Lawnmower Repair Briggs And Stratton

i have a push murray briggs and stratton 20 inch i try to crank it up it would not stay crank or idle up could tell me want the problem.

robert
June 2010

Hi Hugo, Sounds like you are having lots of fun. You will have to set your air gap between your coil and your flywheel the gap is .010. Replace the spark plug the gap is .025. I think you might have a fuel problem. Remove your gas tank ( take note where the spring and hook up connect to it ) and dump the fuel out in a white container like a butter tub. If you see dirt and water floating in the bottom you will have to remove the carb. To do this, remove the screws that attach it to the tank, be careful taking it off there is a spring under it and a diaphram. Under this you will see a secondary cup in the tank ( about the size of a thimble ).
Flush out the tank and the cup. Get some carb cleaner and blow out all holes in the carb and the screens at the bottom of the pickup tubes. Re-assemble carefully.
I hope this helps. GOOD LUCK

JOHN @ RONA
September 2005