How can I fix my Dorf Flickmixer tap?

I too was told FlickMixer seals were no longer available, but recently found these: https://tapwarecentre.com/products/dorf-flickmixer-1-2-seals-and-springs
Looks like the seals and springs in the unavailable Dorf SP5850 kit, and fits our FlickMixer just fine.

Neale
June 2017

Do you know where to get new washers. Dorf says these are not available any more!

Jeff
May 2013

Make sure you put the plug in the sink before you start, as small parts can be dropped and finish up in the u bend.
believe me I know

Derek
March 2012

Thank you, you just saved whats left of my hair. I didn't realise that there was something under the logo and I couldn't figure out how to get the handle off. now I have got it. Many thanks.

greg
July 2009

Will do my best to answer this question as I too searched the net for an answer and found no responses. In the end I just had to figure it out for myself.

Anyhow, the tap handle had to be removed first by loosening the hex screw concealed behind the dork red & blue logo. I just used a knife to remove the plastic cap and then an allen key to remove the handle.

I could then remove the cover, which revealed the large bolt that secures the assembly in place. After the bolt was removed I used a pliers to remove the tap lever asssembly. It can be just pulled straight out, no unscrewing required.

This reveals the hot/cold washers, each of the 2 washers sits on a spring in the cavity.

AJ
November 2008