Samsung B12455 error 4E?

i know the belt on my washer is slipping but will this be the cause of it taking so long to go through its cycle
or is this another problem
the machin is about 10 year old and been very reliable until now

mick
September 2012

when i switch the machine on display lights up and beeps but i cannot change any of the features none of the switches work

laura
November 2009

I have found a solution 4E error for my Samsung WD7101CKW. Water that comes inside washer is splitted in splitter with valves. One of these valves has a red label on it - this is a valve with restrictor of flow inside. This restrictor is used to limit flow speed mainly for testing purposes of pressure/water level sensor. Because of that restrictor (red cap with two holes of 0,5 mm diameter) blocked flow too much, after some time washer controller thinks that water has too low pressure.
Unplug washer, disassemble hoses from valves, disassemble valves from the washer (screwdriver needed), drill both holes in red restrictor to 1 mm (use 1 mm drill or just big needle). Assemble in reverse. Will work :)
Greetings - Thomas

Thomas Pirowski
April 2008

Hey 4E error comes in case
1. No proper water supply
2. The Outlet pipe sould be at AT LEAST 60 CM to max 90 CM HEIGHT ie to the height of the washing machine, try putting the outlet pipe to the holder at the back og the machine

rohityadav79@gmail.com
February 2008