I have cleaned the filters,condensor checked the thermal contacts in the back of the dryer with the fault on they are ok,the heater elements glow to heat,checked the wiring could it be the timer? once it has cut out it will not start again for a bout five minutes.
it is a creda condensor tumble dryer model t620cw
Have a look at the On/Off relay under the top panel, It's probably a defective armature coil
Normsky
February 2009
This is mark freeman still no luck with tumble dryer will update if I do,tryed it again after a few weeks still the same
mark freeman
February 2008
to mark freeman did you fix this problem. I have a creda T601CW with the same fault
andy lennon
February 2008
From looking at various sites on the Internet, it looks as though this is caused by a faulty or damp heater in the drier. The advice seems to be to leave the drier to "dry out" for a while (i.e a couple of hours). If the fault is not resolved, then leave it a little while longer. If the fault persists, then the best advice is to get an engineer to look at it. Sorry I can't be more specific.
floyd
February 2008
just wondered if you'd had any luck fixing your dryer as i have the same make and the same problem?
howtomendit.com for free repair help, information and advice.
Try fixfault.com to fix tumble dryers.