creda excel consenser tumble dryer heater fault?

Try pressing the reset button (which can be found behind the rear panel) I had the same problem and thats all it took. Good Luck

Marilyn
May 2010

MY dyer is heating but there is no water going into the water disensor so the clothes are not drying

Mandy Brown
September 2009

Firstly remove the appliance from the mains unplug!! Remove the back. Inspect the element for any burned or broken element springs these are very delicate. if the element looks ok and all the fillaments are intact then suspect the thermostat. Some models have the thermostat sitting ontop the element itself others have the thermostats screwed into the sloped housing above the element. If the element is ok no breaks then replace the thermostats make sure you replace them in pairs. and note what thermostat came from where. This fault is generally caused when there is a build up of fluff in the drier itself and can overheat or even catch fire make sure that the inside of the drier is cleaned from any fluff build up. Another cause is the drier being stopped in mid cycle you have hot air inside the drier and as soon as it is stopped a rush of cold air into the drier usually will burn out a thermostat and they always fail in the case of the drier not heating not the other way around. Hope this helps!

cc
January 2008

remove the back of your machine make sure you have unplugged it first, look for any loose wire's,if everything look's o.k, it could be the element you can get one of these from a online supplier called appliancehelp@ntlworld.com these people are very reasonable with there prices,anyway a friend with a multimeter would be a great help for you,hope this help's

steray
January 2008