How can I repair my Creda Tumble Dryer?

I agree with the previous answer. But a problem I had was that the seal between the drum and the front panel had worn, which meant that air was being drawn through that gap rather than through the heating element, leading to the element overheating. Again, the element thermal cutout would operate.
So could be fluff, or could be an air leak somewhere.
James

James
December 2007

The problem with this one is that the back of the drum will be packed with fluff, and this is causing the over heat sensor to cut in early. The only real cure is to open the thing up for a clean - chances are you'll be amazed how much fluff is in there!

John
December 2007