If the filter won't unscrew it is probably so choked up with rubbish that the rubbish is catching on something and stopping it from turning. If it was me I would tip machine back against wall, get under and remove the pump from the other side. Not an easy job for a novice. Either that or force the filter and break it. Then buy a new filter and clean it out more often. Are you sure that the filter is leaking. Have you actually looked and found the source of the leak (where the water starts from)If you can't actually see it leak, I would leave it alone for now and look elsewhere. Sometimes it is a small spit or pin hole in the rubber door seal.
front control knbob loose how to repair?whe i turn on machine the control knob is loose so i can not progeam th e washing machine...Click here for the answer
Multipoint wd440 rinse hold and power lights flashing?Hi, our washing machine will start to fill and the drum will turn a couple of times and then stop, and the rinse hold and power lights start to flash while it drains the machine. I've had a look at the circuit board, but haven't a clue what I'm looking for or at. Everything looks clean and dry. The ...Click here for the answer
Broken machine?My washing machine is a washer dryer and starts for a few seconds but then just stops . Any ideas?...Click here for the answer
How can I fix my Simpson EZI set 7.5kg simple wash?My Simpson 7.5kg EZIset simple wash machine as it has lost all power. there seems to be no fuse under the control panel to check....Click here for the answer
fisher paykel GWL 11 96151B?washer was slow filling on cold water. Replaced the cold water inlet valve and it filled faster for one cycle and then stated giving me a code 49. Replace the cold water valve a second time and still getting the same code. occasionally it will not flash and start to work but then it stops and the...Click here for the answer
Hotpoint WD440 is tripping mains RCD?Hi,
I have Hotpoint WD440 washing machine, recently it started tripping the mains RCD.
I googled a lot and disconnected the pink wire which is connected to the heater.
I have tested the continuity of the heating element which is fine and it's not borken.
It works fine and doesn't trip mains RCD...Click here for the answer
How do I remove sop dispense from machine to clean it ?How to remove soap dispenser drawer from machine to clean it service 120"A...Click here for the answer
repairs can be dangerous.
In many instances work should only be undertaken by a qualified
professional. Ensure you have read our Small
Print page before using information supplied via this website.