Differences between liquidisers for A700 and A900 series?

Coupling Conversion A900/KM series to A701/A707 series

This procedure must be undertaken by a suitably competent person, as it involves handling sharp blades.

The A701/A707 series liquidiser is no longer available, however, this can be overcome, either by adapting the coupling of the current A900/KM series liquidiser to fit A701/A707 liquidisers (models A788/A788G), or by converting a complete current liquidiser.

Use the two piece liquidiser base from either the A993A/A994A (interlock version) or the A993/A994 (non interlock version)

Please note: these bases are not interchangeable and must be used with the correct goblet goblet – see the website for full details



Remove the coupling assembly from blade hub assembly by:

covering the blades with a thickly folded cloth and holding steady, whilst at the same time turning the coupling assembly in a clockwise direction, using a suitable tool such as a large flat blade screwdriver

then cut down the coupling to measure 16mm from top to bottom, use a file to smooth the rough edges of the modified coupling

A788/A788G bases only
Please note: when fitting a modified coupling to an original A788/A788G base, reassemble using the shim washer only – do not refit the thick zinc washer

Dave
October 2008