How to mend Fitted New Pump

1

Central Heating and Water on continuously?

New CH pump fitted a month ago by a registered plumber. Since then the Central heating and water runs continuo... [Read more]

2

Zanussi FLE 1416W washer?

I have just had a new pump fitted to this appliance, however, my main light on the on/off switch is on, anothe... [Read more]

low pressure in shower?

I recentley had a new shower fitted and the pressure dropped its fed from the tank in the loft cold water with... [Read more]

why won't my boiler stay alight?

I have a potterton suprema 70 boiler... boiler won't always ignite properly.. press reset, ignites for few min... [Read more]

hotpoint washing machine will not drain?

Hotpoint WM83 will not drain? Hi, I've a Hotpoint WM83 washing machine and recently it will not drain the wat... [Read more]

2

Camray 5 'lockout'?

I have a Camray 5 external boiler. It is three years old and keeps running pumps. It has the new Riello G RGB ... [Read more]

1

my boiler will only run with heating and hot water ?

my boiler will only run on central heating and water instead of hot water only.a new pump was fitted by an eng... [Read more]

3

Worcester 19/24 CBi Constantly locking out?

I have a Worcester 19/24 CBi boiler (4 years old) which keeps locking out whenever I put the central heating o... [Read more]

1

Hot Water but no CH Potterton Netaheat Profile 30e-80e?

In the last day or so we have noticed that we are getting hot water but no Central Heating (rads are cold etc.... [Read more]

1

ford transit 2.5 engine starting problem?

hi i have a reconditioned 2,5 engine in my boat it used to start first click but now it takes a few turns then... [Read more]

Drain pump packed up, replaced but will now not fill?

Matsui MS2S Dishwasher. Drain pump stopped working, fitted a new one, starts to fill then immediately empties.... [Read more]

2

plumber said there is water in tank?

hi we are having problems with are warm flow boiler are plumber said we had water in are tank he drained it a... [Read more]

Nissan Primastar "sticky" engine performance?

I have a 55plate 1.9dci primastar which has covered 95000miles.Had a service done at 90k where it needed a new... [Read more]

starting problems & lack of power?

I have an 2004 2.5 td ford transit van, with problems starting, or if left standing for more than an hour. H... [Read more]

1

zanussi jetsystem 1200 fjs 1225w?

i had to fit a new drainage pump. once fitted it came up with an error code e90. i've cleaned the contacts and... [Read more]

1

new valve and pump fitted heating fine no hot water?

Just had an engineer to fit a new c/h pump and 3 way honeywell v4073a motorised mid position valve to a combi ... [Read more]

1

heating?

My fuse keeps blowing have had a new pump fitted new thermostat new clock and pcb board. The fuse still blows.... [Read more]

1

Supprima 60L not heating rads etc ?

Further to the question on rads taking hours ton reach full heat A new pump was fitted 2/3 months ago. Is it p... [Read more]

3

How can I fix my Zanussi Jetstream FJ1033 Washing machine?

During a washing cycle a fault occurred which tripped the RCD on the kitchen circuit. The machine was still f... [Read more]

2

THE WORKINGS OF A PUMPED C/H SYSTEM AND AGRAVITY FED H/W?

I have an Ideal WLX RS50 Boiler.I recently fitted a new 2 port zone valve and pump in the c/h .All operating o... [Read more]