How to mend Alarm Sensors Control

2

why does my house alarm alert me to a tamper. ?

Last year I moved my house alarm control box. after the move I carried out a test although it wasn't going to ... [Read more]

2

Veritas 8 alarm, cut through sensor (pir) wire - help?

Hi I was recently doing some DIY and removed a skirting board. Unbeknown to me inside it was the wire that l... [Read more]

3

How can i fix my Veritas R8 Alarm?

I have changed battery in above alarm, how do i get my zone sensors to detect when alarm is set.( No red light... [Read more]

scantronic9448?

hi can any1 help my alarm went off at 3am this am i put in the code the tamper light remained on the main pane... [Read more]

2

sensors no longer active on my citadel xr2 alarm system?

I unscrewed the kitchen sensor in the kitchen to paint the wall behind. After relocating it i now find that al... [Read more]

1

Accenta G3 only 2 zones make the alarm go off?

I have an Accenta G3 Alarm system filled to my house. When I perform the walk through test, all the sensors li... [Read more]

1

VERITAS 8 ALARM FAULT?

I was moving one of the PIR sensors in the romm when all of a sudden it stopped working, no light or nothing, ... [Read more]

1

How Do I Stop my Norweb sensor from beeping on a Veritas Alarm?

I've got a Veritas alarm system that has a number of Norweb sensors attached. Early this morning the one in t... [Read more]

accenta g4 led panel,?

i have fitted 3 more zones to alarm system, 1 room sensor, 2 door sensors and my control panel will not recogn... [Read more]

1

Melcom K6500 Alarm - Control Panel stopped Working?

I have a Melcom K6500 alarm (keypad). The main alarm ahs the usual lights on (I think day mode) but the contr... [Read more]

WHATS WRONG WITH THE SENSORS?

I have been using the alarm for 12months and it has been fine,last week it would not reset,and when it did two... [Read more]

1

alarm code reset number?

i have an veritas r8 plus alarm system i cut through the wires but have repaired that it blew a fuse on the c... [Read more]

1

tamper problem?

hello, i need to install two new sensors and remove one door contact in my house and need help on how to insta... [Read more]

2

Power cut has placed a fault on my house alarm?

The power at my house went off for 2 hours and now I cannot set the alarm, the alarm is a veritas r8, 12 year... [Read more]

1

How do I reset the tamper on my accenta alarm?

Hi I have just finished decorating the hall and had to remove covers from the two sensors and the front cove... [Read more]

2

tamper light on and control panel locked out optima xm burglar alarm?

I recently bought a house with the optima xm alarm system already in it(which has been working fine),until i s... [Read more]

2

Accenta alarm, cannot set system?

Hi, I cut through the cable that was wired to magnetic sensors on exterior doors. This had been disconnected ... [Read more]

3

How to operate a veritas control panel for my home alarm?

Just moved in, and have the code for the alarm and that is all. Does anyone know where I can obtain the instru... [Read more]

1

how can i fix my house alarm?

hi,i have got a newland alarm the problem i have is the power got turned off in the house when it got put back... [Read more]

5

Scantronic Alarm system?

I moved into my bungalow April 04 and it has a Scantronic 9452 house alarm fitted by Pheonix alarm systems an... [Read more]