How to mend Alarm System Work

How can I reset my 9427 scantronic system ?

I have a 9427 scantronic, the alarm went of randomly I turned it off using our normal code tried to turn alarm... [Read more]

1

Disconnect alarm system?

I have recently moved into a house with a Eurosec CP8L alarm in place. HOw do I safely switch the system off w... [Read more]

Melcom ST6000 PIR down?

Hi - we have a Melecom ST6000 alarm system, Doing some building work and removed a PIR. Reconnected, but now n... [Read more]

4

Can I use a Scantronic 9448+ panel without door contacts ?

I have replaced my old security system panel with a new Scantronic 9448+ model.. Originally did not have Door ... [Read more]

Correct NVM chip for a Scantronic 9827?

After replacing the battery recently I needed to reprogram the system. I don't have the engineer code so follo... [Read more]

1

Why, after reconnecting power, is our key pad not accepting the code?

After reconnecting the consumer unit does the Texecom Veritas alarm will not work? We have reconnected the in... [Read more]

7

Accenta 8 outside siren not working?

We recently had some painting work done to the outside of the house and the contractor (bless him) silenced th... [Read more]

vauxhalcar alarm?

can any one with a 2004 sxi 1.3 deisal corsa tell me if they have ever seen the alarm neon in the hazard switc... [Read more]

1

SL compact alarm?

Hi I have an SL compact alarm system with 3 separate key pads . The problem is there is no red power L.E.Ds ... [Read more]

1

Scantronic 9454 - tamp/fault/service?

Hi Just moved into a new house and when electrician was installing a new consumer panel, he removed the fuse ... [Read more]

1

how do I disconnect the alarm system?

I have recently moved int o a house with this system in place, wee had the power off and the alarm went off, t... [Read more]

19

9600 alarm aux problem?

hi there to cut a long story short i have replaced all my motion detectors on my scantronic 9600, i have fitte... [Read more]

6

No 12 v output from panel?

I have just replaced a faulty pir that was damaged during some decorating work and now there is no 12 v output... [Read more]

16

My Optima XM won't accept security codes- day and power buttons light up?

I have tried to set my Optima XM alarm using the security codes. The day and power buttons are lit up and all ... [Read more]

4

Why won't the alarm bell work on the G4 optima alarm system?

The bell will not work on our G4 optima alarm system. I have checked the wiring and there is a positive and ne... [Read more]

1

How to reset a 9427 alarm?

Hi there. I have a house with a 9427 alarm system. I've had the house many years and the alarm used to work fi... [Read more]

2

Zone fault?

When I put on my alarm zone 1 light stays on,which is the window contacts,how can I reset it to work with the ... [Read more]

10

Troubl light is on?

I have an Ranger American alarm system that 7 years old. We have never used it as an alarm system, but it is o... [Read more]

4

Is it possible?

Is it possible to install a modern wireless alarm system that can send a 12 volt hard-wired switching signal t... [Read more]

2

Intruder alarm sounder not working?

The alarm sounder on our alarm system does not work when the alarm system is activated although it sounds when... [Read more]