Boats, Powerboats

Fuse harness replacement on a wave runner?

How difficult is it to replace the fuse harness on a 1998 Yamaha GP1200?

Engine stops when I go a stern?

I've got a 5.7 V6 stern drive Mercruiser,it engine konks out when I put it a stern.Can anyone tell me why thi... [Read more]

noi have crt tv philips the powers light is bli?

i have crt tv philips the powers light is blink no work

water not pumping out?

I have a suzuki 90 hp outboard engine.Water is out of the exhaust but doesn't come out as a stream.It just spi... [Read more]

sea doo trouble ?

it revs excellent but when in water it struggles so bad and goes 15 miles per hour than after 20 mn it may t... [Read more]

overheating 2003 suzuki df115?

what is causing a 2003 suzuki df115 to run hot causing the temp light to come on? I turn the motor off then o... [Read more]

Yamaha 75 outboard?

Yam 75 loses power at full throttle for about 30 seconds then comes back to normal. Any ideas.

How to check for a bad ECU on a 2008 waverunner fxho?

How to check for a bad ECU on a 2008 waverunner fxho. My jet ski has high oil level, looked like fuel was comi... [Read more]

Yahama 760 waverunner no gauges work?

I just bought it,I only have warning lights on no speedometer or fuel or oil levels any ideas? It runs great j... [Read more]

need startup procedure on 2 diff 40hp mercs?

these motors have sat a while and I haven't a clue whats first but gas and battery. if someone know the lon... [Read more]

what is propper procedure for cranking two merc outboards 72-400?

i have two mercury outboard engines. a 72 and a 79 BOTH R VINTAGE 4O HP. the 72 sank was drained and a new car... [Read more]

changing water impellor?

what are the steps required to change the water impellor on the suzuki dt5 outboard motor?

How do you remove tamper caps on high and low adjustment screws on my 1200g?

How do remove the tamper caps on high /low adjustment screws on my GP1200R waverunner 2001 (mikuni carburetor ... [Read more]

XL750 Code Problem?

I have a XL750 as well and tried to reset the code by unplugging the blue wire in front, holding down the code... [Read more]