How to mend Alarm Control Panel House Alarm

1

CEF AP28 alarm issue?

My CEF AP28 alarm control panel "24" light came on the other night and was beeping. We entered the code and th... [Read more]

1

All lights on TS510 small control panel in garage?

I switched off mains electricity to replace kitchen socket. When I turned on the elec again all led lights hav... [Read more]

1

Optima 2 plus house alarm?

Having replace the battery the alaem goes off , i can reset it by entering the code. however "A" flashs on th... [Read more]

1

veritas alarm cannot be reset or accepts code?

I had to disconnect power on house electrical board in order to fit new sockets switches and dimmer switches f... [Read more]

1

Scantronic 9454 - tamp/fault/service?

Hi Just moved into a new house and when electrician was installing a new consumer panel, he removed the fuse ... [Read more]

1

Home alarm systems?

Following a power cut our Cooper Menvier 9427 panel has no lights on left hand side on the operating control p... [Read more]

2

How to stop bleeping noise from control panel after mains power cut?

mains power went off in house and alarm ran off battery which has not been replaced in over 10 years. When mai... [Read more]

2

Friedland Wireless Alarm 433mhz?

My alarm has been working perfectly for 7 years and now the remote control is not communicating with the contr... [Read more]

17

9751 alarm with tamper fault?

Folks, I have inheritted an alarm system with the purchase of a new house. It's a Watson Alarm system but i... [Read more]

6

alarm goes off after setting and departed from property?

cooper menvier 9448+ alarm system having set the alarm and departed from my house the alarm sounds.On re-enter... [Read more]

11

Veritas 8?

The alarm on my house has never been used for years. I think I know the code but I am not 100% sure. The Ver... [Read more]

1

Nexus 8 alarm?

Nexus 8 burglar alarm bell/strobe activated 6/1/13 even though system not set, i.e. house was occupied at the ... [Read more]

4

Risco GT-480 Strobe stays on?

Hi I recently moved house, and there's ageneric alarm fitted. I've tracked it down as a Risco, the control pa... [Read more]

4

gardtec 800 alarm system reset?

I have a gardtec 800 series alarm system. This was installed by the previouse house owner. Last night the inte... [Read more]

3

LP1-4000?

We have just moved into a house with an alarm on the front of the house the control panel is in the hall way b... [Read more]

7

ReActivate Micromark MM9490A Burglar Alarm?

We have moved into a new house and the alarm has power to the control panel (led working and when I trip the p... [Read more]

1

How can I change the entry time on my Tunstall TS500, please?

I have recently moved house and would like to lengthen the entry time on my TS500 alarm. As I am unable to ob... [Read more]

5

How can I de-activate my house alarm?

My house alarm is sounding, however there is no power to either the control panel or control box. All of the L... [Read more]