HOW DO I FIX MY HOTPOINT WASHING MACHINE ?

hi, my hotpoint washing machine an Aquarius Ultra Plus, 1200 microprofile 9559 (long winded - hung of junk) has decided to show me an error code E14.

can anybody enlighten me to what it means and how i go about repairing it without taking out a 2nd morgage.

the price of fuel is high enough without me feeding the kids more bread and water in our fantastic over priced and under payed country

no not bitter & twisted - just sick of my taxes going to those who wont help thereselves.

Steve the fustrated
May 2004

HI, MY NAMES ALAN, IM RETIRED AFTER 37YRS IN MY OWN DOMESTIC APPLIANCE REPAIRS, STEP1, KNOCK OFF BOTH WATER FEED TAPS, 2, PULL OUT THE WASHER FROM ITS NORMAL PLACE WATCHING AS YOU DO SO YOU DONT RIP OFF BOTH FEED WATER PIPES, ALSO THE DRAIN PIPES, GET THE WASHER IN A POSITION SO YOU CAN REMOVE THE TOP, THIS IS SECURED BY 2 SELF TAPPING SCREWS, BEFORE YOU REMOVE THE TOP DISCONECT THE POWER PLUG FROM THE WALL, THIS IS VERY IMPORTANT AFTER YOU REMOVE THE TOP YOU WILL SEE THE ELECTRIC MOTOR WITH A MASS OF WIRES ON IT, DONT BE DISTURBED BY THIS,3 REMOVE THE PLUG FROM THE BACK OF THE MOTOR WHICH WILL PROBABLY HAVE A NYLON BAND SECURING IT,CUT THIS OFF AND PULL OUT THE PLUG,4 THERE ARE TWO BOLTS SECURING THE MOTOR TO THE DRUM, REMOVE THESE AND THE RIBBED BELT, TAKE OUT THE MOTOR ,LAY IT ON A PIECE OF PAPER BECAUSE IT WILL HAVE CARBON DUST ON ITS BODY, 5 PUT A SCREWDRIVER BEHIND THE BRUSH HOLDER TAGS, AFTER TAKING OFF THE SMALL ELECTRIC WIRES, PUT A SMALL SCREWDRIVER UNDER THE PLASTIC BRUSH HOLDERS AND LEVER UPWARDS,THESE HOLDERS CAN NOW BE THROWN,6 WHEN YOU INSERT THE NEW BRUSHES IN THEIR HOLDERS YOU WILL HAVE TO FREE THE CARBON BRUSH BY USING A SMALL NEEDLE THE BRUSHES WILL THEN SPRING OUTWARDS,.7 WHEN FITTING THESE TO THE MOTOR TAKE YOUR TIME AS THEY BREAK EASILY IF YOU FORCE THEM,YOU JUST THE FOLLOW THE SAME INSTRUCTIONS IN REVERSE, HOPE THIS WILL HELP YOU ALAN (WASHER MAN)

ALAN THE WASHER MAN
May 2004