How do you change circuit board in kenwood chef A901?
Capacitor in circuit board blew, obtained and fitted new circuit board, speed control for some reason is just one speed?, Have i wired it correctly? what gap do i need to set circuit board from rotor, to allow variable speed?
Hello Liam Moshe Jerusalem
The Circuit board distance from rotor shaft is varied by slotting the pin which juts out of the CB into the groove in the round plastic part which is attached to the on /off controle Ie. the controle numberd knob, As the knob is hand turned to a higher number the distance grows.
Moshe Bar
April 2007
Automatic Answer
We may have found other answers which could help you.
howtomendit.com for free repair help, information and advice.
