Kenwood KM600 motor doesn't operate when drive is mounted?
I have a Kenwood KM600 that ceased to work some time ago. I replaced the control and it now works fine until I mount the drive belt.
Once the drive belt is mounted the motor doesn't spin. I assume the torque required is too high. Spinning the belt by hand works with out resistance in the gearbox, so it should work. The contraption can be spun by hand but not by the motor.
Assuming the torque needed is enough to hold the motor it would probably be that the rotor cannot have enough amps = resistance between coals and rotor. But this measures - as expected - close to zero ohms.
Any suggestions are welcome.
Kenwood mixer?Keeps cutting out. Reset button press makes it work but then cuts out again after 10 to 20 seconds or so
Any advice?...Click here for how to mend it.
Has any one got a wiring circuit diagram for kenwood chef model A901?has any one got a wiring circuit diagram for kenwood chef model A901?...Click here for the repair.
repalcing motor Kenwood FP615?How do I dismantle the FP615 to replace the motor. or get instruction manual for doing it...Click here for how to mend it.
I have smoke coming out of kenwood a902 chef excel?I have a kenwood a902 chef excel mixer and was using it and smoke was coming out of the motor housing it is about 28years old but a great mixer . Can it be fixed and how?...Click here for how to mend it.
Can it be fixed?My beloved Kenwood Gourmet A535/A536 went 'fizzle, pop', and smoke came out. Does anyone know what might have gone and if/is it worth getting fixed???...Click here for how to mend it.
How can I fix my Kenwood Chef Classic?My Kenwood Chef Classic (only a few years old) mixes at max speed all the time. Any suggestions which part needs replaced or adjusted?...Click here for the fix.
repairs can be dangerous.
In many instances work should only be undertaken by a qualified
professional. Ensure you have read our Small
Print page before using information supplied via this website.