i have a kubota r320s and the shut off solenoid wont work?

found the problem with the kubota there was a harness connection problem under the floor. this harness connector is not shown on the parts list or the schematic so i hope this helps someone else with similar problems.

foster138
February 2016

thats ovious

bob
February 2016

To operate the solenoid - it needs to have 12v across it - a differential so that current can flow. If each side is 12V then no current can flow. Similarly if each side were zero volts there would be no current flow.

You would do well to investigate just what it is that makes one of those 12 volts go away at shut-off time.

I know nothing of tractors - just very basic electricity.

Good Luck...
February 2016