Scantronic 9425 zone settings question?

See how part set is now then if its not set up for your requirements then reprogramming is needed .

It's easier if you read through the installation manual as I don't know how your system is set up entry exit route etc.

Do you have the manual it's very basic and easy to follow.

davo
December 2014

Thanks Davo, that's what I wanted to hear. How do I do it though?

Tony
December 2014

No but if you are not using the part set feature on the system then you could program that up for your 2 zones.

So in effect you start your set with 2 enter **** instead of the no 1

davo
December 2014