Hi, the bathroom wiring was damaged but unfortunately the plumber has chased into the wall and is now covered by wall panels. Now the sensor (all the sensors in the house) little red lights do NOT work. I could re-wire the last three or yards back from the bathroom sensor. Question: has do I go about cutting that cable and rejoining a new cable to get the sensor lights working again?
Colmar February 2014
cut cable = blown fuse in control panel remove mains power before opening the control panel replace /repair the cut wire
showing zone 6 and 7 open and wont arm?i have got scantronic 9651 ewith 9943 keypad. it was working fine till there was a power cut for 12 hours. when power came back the time gone to default time and the alarm wont set. i changed the time and put the original code back but now when i try to set it says zone 6 & 7 open....Click here for the fix.
alarm goes off during night . no intruders?alarm system accenta/optima G3 intruder system.
Alarm goes off in the night for no reason.
Can anyone tell me why. Quite old model, perhaps
I need a battery change....Click here for the repair.
Tamper Light?Hi the power went off and when restored I the tamper light has stayed on I cannot set the alarm, I have tried shorting the tamper pins on the system but it still stays on, so thinking it caused a fault got a new system keyboard and panel wired it up the same and guess what exactly the same, could yo...Click here for the repair.
repairs can be dangerous.
In many instances work should only be undertaken by a qualified
professional. Ensure you have read our Small
Print page before using information supplied via this website.