Kenwood FP520 Food processor?

You smash it open and ppthrow it out of your window then you put it in fire there you go

MrHacker
February 2017

Peters solution works but how on earth do you put it back together again having placed the belt I can't get the vent screws in.

jacal
May 2015

1. Remove the 5 screws from the base
2. Remove the dome at the base of the main shaft , push up with a flat blade screwdriver
3. Through the grill at the bottom, remove the 2 chrome screws. A pt1 pozi will do this
4. Now remove the base
5. Lightly grip the motor drive spindle with grips
6. Turn unit upside down
7. With another pair of grips turn the white plastic cog at the other end of the motor shaft clock-wise.
8. This will release the motor
9. You should now see how to fit the new belt

peter
July 2008

I tried my hardest then found if after opening all the bottom screws then there is another underneath inside the vent. You hold this whilst on the top you turn the bit on which the liquidiser sits clockwise and this will allow you to seperate. Even I waas trying to put small screwdrivers inside to release the plate inside until I realised

Kaleem Ullah
January 2008

I am facing the same problem. Did you find a way to get the bottom plate off?

Mark
April 2007