how to disconnect one pir, Accenta6 alarm?

have Accenta6 alarm. want to omit one detector so I can move around upstairs. how do I do that ?

pam

July 2013

There is more help available. Mend - one, pir, alarm

Have you tried using the part sets (PROG) 2 or 3?.

That sensor may have already been programmed for omit in one of the part set suites.

Check:

Pop your code in then press (PROG) then either 1,2,or 3,.1 being the full set or 2 or 3 being part sets,now press (OMIT) then the system will display the zones about to be armed.

Now press the corresponding number of the zone you wish to omit and the zone led will go out,now press (SET).

You have now set the system with that zone omitted.

e manno

July 2013

Add An Answer Form

Add your answer using the form below ...

Other questions in this category - Security Systems, Home Alarm Systems

How do you turn off low battery alarm on an ACCORD XPC system?

Bought house don’t have ADT contract and have inherited old alarm...

Click here for the repair.
Scantronic 9800 problem?

Hi, this morning I unset my alarm (28 years old) and as I am doing some electrical work in the kitchen, I needed to switch the house power sockets off at the control box. Immediately my Scantronic activated the internal alarm with code LB (low battery) but despite entering the code it would not ceas...

Click here for how to mend it.
I have a scantronic 9827 displaying tr error code?

I have recently replaced the battery to my 9827 and I can't get it to work now, it just displays tr error code. How can I clear this code?...

Click here for the fix.
eurosec CP8L Replacement Battery failing?

We had some work done on the house last year and the electrics were disconnected for over a week. Once reconnected the alarm said low battery. I bought a new battery, tested it to make sure it was charged and then popped it in the unit. The leypad still said low battery but I thought maybe it jus...

Click here for the repair.
i-on 16 ?

i am having problems after a power cut i am getting 'panel A/C fail' i have gone into the main consumer unit and checked fuse, and replaced, but its still not working well not from the mains just the battery that has now gone dead any suggestions does anyone know anyone that could fix this in th...

Click here for the repair.
How to turn off door chime when entering/leaving?

How do I turn the chime feature off so I can leave enter in peace? Thanks....

Click here for the repair.
Keeps going off,,,when NOT set?

My 9448+ will go off in the middle of the night and we have'nt even set it?....Any ideas?...

Click here for the fix.
Hammer symbol on red??

I removed a carpet which had an alarm cable underneath I did nothing to the cable but the alarm went off now the hammer symbol is on red the system is not working how do I reset it, nothing works on the key board ie I have put 1234 and still nothing please help...

Click here for the repair.

			Ask for free help
:: home :: add a question :: search		:: help :: most recent :: unanswered
	Search: Go