How can I fix my Firebird 90 oil burner?

I am not always well and not always right but people like you keep me and others going. Thank You.

Old Guy
February 2012

I would like to thank you all for your help. I identified a number of problems with the burner. Fuel line damaged, Fan vent not opening properly and hydraulic piston leaking. Blades on fan damaged. Unable to remove it as it was rusty. The controller board was also corroded and it only supplied power to the electrodes intermittently. Optical sensor also corroded. The filter in the fuel pump was clogged and damaged. I cleaned the combustion chamber and replaced the very old burner with a new one. A lot happier now that all is working well. Thanks again.

john
February 2012

Thanks Old Guy. Must Buy a pressure gauge at he weekend.

John
January 2012

Did you not know the pressure is adj. with a gauge?

Old Guy
January 2012

Hi Stephen, thank you for your reply. I have cleaned the boiler. It is quite old and very dirty. Just moved in to this place. I'm not sure if the pressure is adjusted correctly. The pressure screw seems to be adjusted out ,anti clockwise. One more turn and it might fall out. It takes a while to ignite and then stops heating after about 40 minutes.No more heat after this. Sorry for being so vague, it must be hard to comment on something you cant see.

john
January 2012

have tried the compositor in the burner or have you cleaned out your burner

Stephen Byrne
January 2012