My Peugeot Ludix Snake wont cold start!?

My ludix blaster since day one of buying it wouldn't start plenty of fuel and spark so cleaned the jets and lifted the needle 1mm with a washer (no needle adjustments) it now runs and starts nice,maybe Peugeot had to run them lean for emissions :-)

shane
May 2013

cool well good luck with that dan.adam

adam bike doctor(of milton keynes motorcycle centre)
February 2011

Just brought it! Hope it sorts the problem out Cheers for the help.

Dan
January 2011

wow thats not cheap is it,they dont do a universal one as they are all different sizes i think these bikes use a gurtner carb so i would suggest just buying a used carb of ebay mate
110641191395 check this out on ebay put the item number in the search bar on ebay

adam bike doctor(of milton keynes motorcycle centre)
January 2011

Thanks mate, looked at that and it is the auto choke, can i replace with a universal one (cheaper) or do I need to go for the expensive genuine part (about £100)????

Dan
January 2011

Thanks mate, looked at that and it is the auto choke, can i replace with a universal one (cheaper) or do I need to go for the expensive genuine part (about £100)????

Dan
January 2011

well if the fuel is fresh and the carb jets are definately clean including the choke jet then it may be either a faulty auto choke or it may be low on compression,also if the tick over has been wound in too far it will not start as it gets too much air when it wants more fuel,so basically if you ahve turned the tickover up to get it to idle then the reason for having to turn it up may be a lack of compression and the open throttle will not let it start.

adam bike doctor(of milton keynes motorcycle centre)
January 2011