Brother KH260 and KR 260 knitting machine and ribber needle problem?

Something for chunky knitters to try. I wanted to knit a particular jumper first I did a test square by hand and on the machine, I matched the machine and my hand knitting. I knitted the front by hand , it was a relief pattern of trees on a gt st background. The rest was knitted on the machine. That was a lazy way of making a special jumper.

Elaine Crook
November 2021

Take the sponge bars out when the machine is not in use for long periods so there is no pressure on the sponge itself. They will last longer.

Elaine Crook
November 2021

i cant get carriage to select needles when patterning fairisle it knits ok on plain on the main bed thanks

Eileen
May 2011

I've had same problem, I change a sponge on bar and it's ok now

Alyona
April 2011

Sorry ! The answer I gave was related to the ribber (KR260)only. The retaining bar for the top bed (KH260) is longer so you will have to search the web for a replacement.

Mike
April 2011

The needle retaining bar is not doing what it should do,these are difficuld to get now but a retaining bar for the for the top bed of the four ply machine can still be got, this will do except that it will not hold the end needles(last needle on either side)which are seldom used anyway, hope this helps.

Mike
April 2011

Hi, Yes it does look as if your sponge bars have gone. You can get replacements from BSK. They have a shop on Ebay where they sell them and also you can contact them direct via their website.
Hope this helps

Deborah W
February 2011

Hello Eirian R,
It sounds as if you need to replace the sponge bars. Over time the foam degrades and does not exert enough pressure on the needles, causing the problem you have described.
A search on the Internet will give you various places which can supply them.
Regards,

Sue
January 2011