Generally - expose the screw that holds the tap head on ( the bit that you turn). Undo the screw and pull the tap head off. This will reveal a large hexagon which forms the tap insert - use a good fitting spanner and undo the insert. Look for the rubber washer on the insert bottom. It may be held on by a brass nut or may simply push on. Replace the washer with one of the same size. Screw the insert back in, but turn the tap on a bit so it doesn't crush the washer when you tighten up. Replace the tap head, do the other one and test. Enjoy!
John
October 2009
howtomendit.com for free repair help, information and advice.
