I'm trying to recondition my Qualcast strimmer, but cannot get the fuel pipe on - should it be this tight or is there a trick to getting the plastic pipe over the ribbed ends?
However i've replaced the fuel pipe and spark plug, but still can't get it to start? There a decent amount of resistance when I pull the cord but it just won't fire - is there anything else obvious I should be looking for?
DIYstarter
August 2009
cheers wirecutter manI'll give it a go
DIYstarter
August 2009
lighter WILL START A FIRE if pipe still contains FUMES much BETTER (safer way) is to hold the last 1/2" end of plastic pipe in BOILING WATER then slip it on the ribbed end.
wirecutterman
August 2009
Cheers John,
Would a lighter do the trick if i don't have a hot air gun?
DIYstarter
August 2009
Just heat the pipe up gently with a hot air gun, and it will slip on, no problem.
John
August 2009
Automatic Answer
While you wait for answers, we may have found some information which could help you.
howtomendit.com for free repair help, information and advice.
