Hotpoint WD72 Washer Dryer?

same problem took back off make sure you unplug from mains removed lower black pipe if you pull one side off carefully and use small bowl you can drain the water with out making a mess also lay towel underneath found several hairclips and a small plastic bag blocking pipe put everything back and all sorted no fault codes thank you for help

leigh hodgson
March 2012

Good thread. Found a sock in the water outlet. Good tip from above, tip the washing machine onto front, empty first though.

dj
January 2011

Thanks for the advice - I had this same problem with my wd 72 yesterday, removed the back and explored the black hose down at the bottom left (not sure what the technical phrase is for this...) and found an assortment of plastic stuff that was clogging the outlet. Just like to say as well that the user guide was useless...

phil
November 2008

I've had the same problem on my WD72 - it wouldn't empty and reported E15.

I followed Nick's advice (thank you) but the filter was clear. It was only after I took the pump out (with the intention of replacing it) that I found a shoe lace wrapped around the pump's blades.

My tip - roll the machine onto its front to remove the pump. The 2 bolts underneath it are much easier to undo than the three fiddly allen key bolts on the blindside of the pump. Once the pump's out, these final three bolts come off easily to expose the blades.

Ben
August 2006

Hi there
I've had to periodically unblock our WD72 when it comes up with this message. I'm afraid I don;t know the correct terms, but taek the back off and there is black rubber hose that is fastened to the pump at one end and at the other end houses a collector of bits - buttons, socks (the main culprit) etc. usually it is this collector that is blocked, sometime sthe other end too.
Ironically I am on here now because this time I think it's the pump itself that has gone- just did a random search and found this and though I'd share what I've found out.

Nick Roscoe
October 2005