How to mend ... Help 8 Fault Please

What battery ST6100?

Mains orange light flashing and display showing fault low battery. What battery is needed

How to remove lid tamper fault on my 9561 alarm?

I have had to replace the battery and now I cannot remove the lid tamper fault.

whats good to replace a Scantronic 9800 with?

Hi I have a Scantronic 9800, I have been ok at fixing most things that have gone wrong replaced battery's, pir... [Read more]

How can I reset a 9827 control pad?

Hi how do I reset a 9827 control pad after changing the main Box battery. Control pad is showing a constant re... [Read more]

Pyronix Deltabell Plus Backlight fault?

I have installed a Pyronix delta bell plus 2 with backlight on a Texecom Veritas panel. All was ok and now the... [Read more]

Veritas 8 fault?

I have a fault with my alarm that even if its off sometimes it starts beeping as if thew keypad is being press... [Read more]

Zone emits beep when walking past even when in day mode?

how do I stop key pad from beeping when in zone of room strobe. Only one strobe is causing the fault. System i... [Read more]

Low battery fault?

I have fitted a new eurosec cpl 8l panel LCD and I can't get rid of the Low battery fault, there are no visibl... [Read more]

Fault on scantronic 4600 panel?

I keep getting a fault on my scantronic 4600 intruder alarm, for zone 5 (Conservatory). Changed the batteries ... [Read more]

Scantronic 9454 - tamp/fault/service?

Hi Just moved into a new house and when electrician was installing a new consumer panel, he removed the fuse ... [Read more]

Scantronic 9600 Exit doors ?

Hi We bought a house with a Scantronic 9600 alarm already fitted and we had the instructions to change the co... [Read more]

Scantronic 9752 com fault how do I fix this?

How can I cancel the yellow light which is permanently showing as alert fault, says Comm Fault.

Scantronic 9827 resetting problem?

I have a Scantronic 9800+ house alarm with 9827 keypad. Although the alarm was not set, at 0400 today the ala... [Read more]

Scantronic i-on 16 wireless siren problem?

I have installed an i-on 16 system and all is working well apart from the 760es wireless sounder which comes u... [Read more]

ef fault?

I cannot set the alarm as when I type in my code and A to exit it flashes on 1 and when it does its cycle it g... [Read more]

zone fault?

can i isolate a zone fault and disconnect it. panic buttons show as fault can i isolate them and still use ala... [Read more]

9600 alarm aux problem?

hi there to cut a long story short i have replaced all my motion detectors on my scantronic 9600, i have fitte... [Read more]

Accenta 8?

Hello all experts, On re-entering the house the alarm goes off immediately showing zone two at the keypad,can... [Read more]

Scantronic 9800 fault?

My 9800alarm went off for no apparent reason. The display shows b6. I have put the system into Eng. mode and o... [Read more]

Scantronic 9427 major problem?

Hi peeps usual problem started with a power outage followed by the noise,so replaced both 2.1 ah batteries but... [Read more]