Make sure the unit is cold & unplugged. place the unit on the edge of the sink.
Unscrew the cord clip by turning 1/4 turn to the left (towards the back).
Using a coin, unscrew the boiler rinse plug.
Insert the plastic rinse nozle - gently push in & turn 1/4 turn to the right. Ensure the outlet is over the sink.
Connect the other end to a tap.
Turn the tap on gently & allow water to run through for about 1 minute.
Turn off tap
Remove rinse pipe (turn 1/4 turn left)
screw back & tighten the rinse plug (use a coin to gently tighten).
Replace the cord clip.
Next time you use the unit, hold down the "reset" button to turn off the orange light.
If you've lost the pipe, use a jug to pour in 1/4 litre of water, shake the base unit for a few moments & empty into sink.
Repeat with another 1/4 litre water.
Sludgeguts
November 2007