Proform 730 SI space saver treadmill?

You can go to www.managemyhome.com to get a users manual.
My proform 730 si is doing the same kind of thing, we have had the motor checked and they said it was good. have had the motor control board checked and again no problems. we are giving up.. sending it to treadmill heaven. :)

movin on
August 2009

These motors have capacitors that give them a jump start to get then going from standing still. If the capacitor gets weak or dies, the motor cannot develop enough torque to get the belt running. You can check if this is the case by starting the treadmill and then carefully try to drive the belt with your feet while standing on the belt. Once the belt starts moving, the capacitor is no longer needed, so the belt/motor should keep going. If this test doesn't work, and there is nothing jammed within the treadmill to keep it from running, then most likely your motor is bad.
Hope this helps.

fudd
June 2009

sounds like your motor burnt out.

BTW, I'm looking for and owner's manual for this treadmill. Would you have one to sell?

Thanks

eugeno
June 2009