How to expose engine for cleaning on Electrolux EPIC model 6000 SR?
I need to buy a replacement sensor for my bag lockout sensor switch. It's a round plastic piece and the base cracked off with age. I can't find a supplier. I also need to "clean" the engine parts and intake valve since the vacuum isn't drawing air like it should, but mostly works okay. How can I access the motor, there doesn't seem to be any screws to remove?
I had the same question and the above answer worked. Along each side is a piece of trim molding that has to be slid along the side by opening the bag door and pulling the trim out the same end. It works!
Keith D
February 2006
open the bag door las thought you are going to replace the bag and pull out the rubber side pieces (looks like the molding on the side of a car). One (the length of each side) on each side - this will free up the top. you will have to reach in and disconnect a clear hose before completely rolling over the top to expose the interior. reassembly is just the reverse.
Don
January 2006
I have the *exact* same problem.
I try to gently remove the back with a flat screw driver, no luck (i dont want to break the plastic).
I have looked everywhere for screws, couldn't find any.
Anyone had luck opening it?
Olivier
September 2005
I can answer this question...
How to expose engine for cleaning on Electrolux EPIC model 6000 SR?