INDESIT IS70CS KEEPS TRIPPING ELECTRIC?

Tried all the above although my condenser dryer is a beko that keeps tripping the electric, only had for just over 12 month, as I said we have tried the drying out etc to no avail, but also when the heater element is disconnected the dryer does not run? No lights on the front panel and the drum does not go round? Any idea?

mandy
December 2013

I also had this problem. Removed and cleaned all filters and lied the dryer on its back. It was full of water so I'm guessing some wiring had got wet. Left empty and open for afew days before putting it on for an hour with nothing in it. Make sure it is about a foot away from the wall if possible to allow ventilation. Working fin now :-)

rob
March 2012

thanks for tip mine had water on element behind panel, dried with hair dryer then cleaned filter properley seems to be working ok now

steve mc
January 2012

i unscrewed the back panel of mine as suggested by paul and there was the underwiring of a bra stuck in there. i removed it and now it works perfectly thanks

claire
October 2011

Thanks saved me £ 250 and damp washing -worked a treat

John
February 2011

Thank you for this, just saved the £200 we were about to pay for a new one!

Boniel
January 2011

I found that the float was damaged and not lifting to make the switch that tells you the water tank is filed up, new on order from indesit !

Paul
November 2010

my partner changed the belt on our indesit tumble dryer as it was snapped. but when he put it back together and turned it on, it kept tripping the electric in the house. any ideas?? thanks

TLGeorge
September 2010

Just took the back off did have water inside, dried it with an hairdryer working great now.
Little tip for the future don't try to move it without emtying the water out first, like I did.

Robbie
March 2010

tried the above and my is working fine now. thanks very much.

nick
December 2009

I have dried out the back part on a number of occasions now and it keeps tripping the electric fuse in my house. it works for a few days but then the problem happens again. can anyone help?

Terry Markey
November 2009

just stripped the kidney shapped panel of the back of the dryer found it to be damp used the hair dryer to dry of all damp area put it back together and is now working spot on thank you for the tip

steve harrison
November 2009

yep my dryer was also tripping out.take back cover off and dry with hair dryer take care though if you remove the 2 small screws that hold the element assy it all falls apart bit of a pig to get back to work ,but my dryer now works fine .thanks for the tip.

mark
October 2009

I removed the back panel (the unpainted kidney-shaped cover) and it had about half a pint of water in it. I emptied it and dried out the heating panel with a hair dryer and my tumble dryer is working very well now. No more tripping of electric circuit breakers.

KU
March 2009

i have just carried out the repair as instructed by Paul and my drier is now working perfectly. Thank you very much for your advice you just saved me £200,buy yourself a drink on me.
Simon Walmsley

simon Walmsley
February 2008

I have just called out indesit - the dryer is tripping the earth leakage system - just on 12 months old - the problem is that because of the location of the water reservoir the condensed water is pumped up to it. Apparently if the filters/condenser is not cleaned regularly it can become blocked and then water gets thrown about onto the electrics (I think at the rear) of the machine (you may actually see water seeping from the unpainted metal cover at the rear of the machine) the cover can be removed by removing several self tapper screws and drying the cover and surrounding area etc. may help. Keep condenser and filter clean.

Paul Cowen
February 2008