how can i re-tension the roller sprung blinds in my bailey caravan?

on the bailey ranger you have to unscrew the top and bottom screws that hold the blind and runners to the body of the caravan,then you can move the blinds and runners from side to side,move to the right and lift the actual blind unit out of the runners then to the left and lift out the unit, then you have just the blind unit in your hands.when you have got this far on the left hand side of the unit there are two screws, one for the fly blind and one for the blackout blind, adjust as neccessery but when you release the screw do it slowly so that the adjuster ratchet can slot back into place,then just re-assemble,easy.

maynard1
February 2012

A fair amount of patients? Why's that? Does the spring flail around cutting everybody up therefore requiring hospital treatment? I think you mean patience.

The Grammar and Spelling Police.
February 2011

thanks,never done this before,will let you know how i got on .

graham
August 2010

thanks bud,never done this before,so hoping i dont make a hash of it

graham
August 2010

For a comprehensive guide on repairing and maintaining REMIS window and roof light blinds
the website below may help.
caravanblinds4u.com

John
January 2010

This is not a killer task. It is however one that takes two people if you have never done it before.

You will also need a large clutter free flat space to carry this out and a fare amout of patients. I had to walk away and come back after a brew!

Take blind off the window

Some blinds allow you to retension with out taking appart

See Haynes manual

If yours don't

Remove the white ends. One of these ends is connected to the centrel core that tensions the blind.

If you can help it do not let the blind unravel.

I allowed this to happen and carfully sprayed WD 40 in to
the spring.

The second person can prevent unravelling by holding the center tensioner. If you do this, to tension it further just turn the center shaft in the direction of most resistance. this will add more tension.

When reassembling in reverse order make sure the person hold ing the tensioner does not let go.

If you have allowed the blind to untention. You just have a lot more turning to do and it might take a few goes to gain the required tension.

You can only do this by putting the blind back at the window and tring it out. Be patient!!

Paul
December 2007

Take off the left hand top plastic cap, there in you will find the tensioner which is adjustable with a screwdriver

Tim
July 2007