Have a Hotpoint Aquarius WF340 and on/off light keeps flashing fast?

yes

m.jabbar
April 2014

just fixed this problem, first pop the bottom panel off the front of the machine and drain the water by unscrewing the drainage cap, when water is fully drained remove the cap and check to see what is stuck in the pump chamber (a piece of my sons T-shirt) and remove it, replace the cap and run a quick wash and make sure that the water drains.

fin23
February 2009

hi check which is yours and come back to me

widl codes - light flashing from left to right are numbers 1-4

f01 light 4, motor triac
f02 light 3 motor, jammed/ tacho
f03 lights 3&4 Ntc fault
f04 light 2. pressure sw stuck on empty
f05 lights 2&4, pressure sw stuck on full
f06 lights 2&3, N/A?
f07 lights 2&3&4 heater relay
f08 light 1. heater relay
f09 lights 1&4 eprom/setup error
f10 lights 1&3, pressure switch not sensing
f11 lights 1&3&4, pump/draining error
f12 lights 1&2, communication error
f13 lights 1&2&4, dryer ntc/ fan motor
f14 lights 1&2&3, dryer heater
f15 lights 1&2&3&4, dryer heater relay
f16 N/A
f17 light 4, door lock
f18 light 3 comms error (3 phase motor) power board

f1 and f17 share the same light
Anymore questions or parts required http://www.freewebs.com/msdapudsey1
Just go to the forum

phil grimshaw
June 2007