replace tramission drive belt on cub cadet lt1045?

Mine is a nightmare to change-this has to be the worst mower ever made.

Jim C
August 2012

Very helpful article. The repair took about an hour, but could have been done in less time. As long as the tractor is on jack stands, the job isn't too bad.

Rob
August 2008

I have had to put the belt back on several times since I bought the machine 2 years ago. It is a pain, but can get the job done. The belt finally streched out way too much so I have to buy a new one today. In my opinion, this lawn tractor is a piece of crap. I have had to replace the tire and battery within weeks of owning it and now the belt.

Bob
July 2008

To replace a transmission drive belt on a Cub Cadet LT1045 you need to remove the deck, unplug the PTO power (directly under the engine ), use an impact wrench (you need the speed of the impact wrench because the engine will turn) and a 5/8" socket and reverse the bolt out of the PTO.

The PTO may be sized on there so you may want to tap it with a hammer and a block of wood carefully to release it. Bend the Ears around the Drive pulley just enough so you can put the new belt on. I thread the PTO bolt back in and use a socket wrench to turn the new belt on. I bent the front facing ear back but left the other 2 bent out.

You'll need to put the belt on the transmission pulley first then thread the belt up to the engine pulley. Thread your belt back through the pulleys and tensioner (make sure your spring is strong enough to tension the belt or buy a new one).

The PTO is "keyed" on the shaft, so it's easer to take off the stop that is bolted to the frame and put the PTO on and tighten it up with your impact wrench, then you can put that frame stop back on in the same place. Put your deck back on and you're ready to mow again.

Tony Dean
May 2008

as manual say call the dealer it pain in your butt to do it your self .
real knuckle buster tranny belt is pain

marl
April 2007