ford new holland 7840 error code E41?

Guyz i need your help here... My ford 8340 its showing e41 and smtimes it cnt even move.... What could be the problem

kenny
June 2014

I have a 7840 and these are the codes that come on my dash (CP, C11, C37 and C47) would ny1 help me

Jack
April 2013

12 X 12 C1 (Low) clutch solenoid open circuit

giorgos
January 2013

hi there, just wondering if you found the fault from error code E41? i have the same fault on a newholland 8340 sle

geraint jones
November 2011

hi my 7840 pto wont work under load

aidan
December 2010

The four clutch solenoids (p.w.m valves)are mounted externally on the right-hand side of the transmission case behind the battery and transmission accumulator. C1 towards the front axle fowlled by C2,C3 & C4. they are mounted vertically in a line. The solenoid coils are retained by a nut on the p.w.m. valve stalk this nut is lightly tighten just to "nip" the soleniod coil into postion, do not overtighten.

Ash
November 2009

Thanks Ash
The tractor is a 7840 SLE with powershift gearbox.
Not sure how to swop the position of the solonoids though.

Markned
November 2009

Presuming 16x16 Quad mod transmission. E41 is due to the C3 clutch solenoid open circuit. Suggest you swap postion of solnoid to C2 postion and see if the fault moves, if solonoid faulty E43 will be displayed. Could also be wiring fault in harness.

Ash
November 2009